![]() Flashing it back with correct software makes it go back to normal operating mode and You can try again. When that happens, BSI breaks communication before the procedure is completed and stays in boot mode forever. And so, when the car is staying with ignition on, it will at some point go into Economy Mode, disabling most of electronics. Pin is in EEPROM, but on JC BSI it needs to be put on boot mode to read PIN from EEPROM. Sanks.I'm not sure that I'm 100% correct but.įVDI is doing automatic backup when trying to read PIN. Maybe before work with bsi, i need to do some preparation: put charger with 14.4 on battery, turn ligth on or something else? On what stage begins the problem: fvdi connect to bsi, put this in service mod, reading flash/eeprom. Why flash make corrupded, if pin is laying in eeprom?ģ. ![]() Or it doing it automatically before pin reading?Ģ. Before doing something with BSI i need make backup flash and eeprom? wiring diagram can be easily found on the internetġ. ![]() (04-27-2020, 08:36 PM)dendroid Wrote: (06-30-2019, 12:55 AM)xipsilon Wrote: the bsi flash should be stored in fvdi back up folder, remove the bsi and connect it with fvdi on the bench and write back ori flash and then you can tread pin.
0 Comments
Leave a Reply. |